Water Heater Installation in Albuquerque, NM

What our Albuquerque installation includes

• Removal and disposal of the old unit
• New tank delivered, set, and leveled
• Cold/hot supply connections with code-compliant dielectric unions
• T&P relief valve and drain line to within 6 inches of the floor
• Expansion tank (required by City of Albuquerque on closed plumbing systems)
• Seismic strapping (two straps at top and bottom thirds, ABQ-required)
• Drip pan with drain to a safe location
• Vent connector inspection on gas units
• Combustion-air verification at altitude
• Permit pulled, inspection scheduled, sign-off handled

Tank vs. tankless vs. heat pump in ABQ

Tank (40-50 gallon)

Cheapest upfront. $1,395 to $2,650 installed. 8 to 12-year typical life in Albuquerque with annual flush. Best for households with predictable hot-water demand.

Tankless

Endless hot water, smaller footprint, 20-year life if descaled. $3,950 to $5,800 installed in ABQ. Pays back in 8 to 10 years on a 4-person household. Descaling every 6 to 12 months is mandatory at this water hardness.

Heat pump

60-70% lower operating cost than electric. $2,950 to $4,400 installed. PNM rebate eligible. Best in unconditioned garages where the waste cool air helps in summer. Less efficient in unheated East Mountain spaces in winter.

Albuquerque permits and code

City of Albuquerque requires a plumbing permit for every water heater install. We pull the permit, schedule the inspector, and meet you at the inspection. Code essentials: expansion tank on any closed system, seismic strapping (two straps), T&P drain to within 6 inches of floor, drip pan with drain, sediment trap on gas line, vent slope and combustion air. We hit every one.